REPAIR COMMANDERS CUPOLA (M113A3, M1059A3, M1064A3, AND M58 ONLY)

TM-9-2350-277-34 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
301

TM 9-2350-277-34 REPAIR COMMANDER’S CUPOLA (M113A3, M1059A3, M1064A3, AND M58 ONLY) 0051 00 THIS WORK PACKAGE COVERS: Removal (page 0051 00-1). Installation (page 0051 00-9). INITIAL SETUP: Maintenance Level Direct Support Tools and Special Tools General Mechanic’s Tool Kit (WP 0120 00, Item 62) Sling (WP 0120 00, Item 52) Torque Wrench (WP 0120 00, Item 75) Lifting device with rated lift capability of at least 300 lb (136 kg) Materials/Parts Adhesive (WP 0122 00, Item 1) Clip Cotter pin Drive screw (3) Grease Locknut (2) Locknut Lockwasher (18) Seal Spring pin Spring pin Personnel Required Track Vehicle Repairer 63H10 Helper References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) REMOVAL WARNING Commander’s hatch cover may spring up and injure you. Open hatch cover and support in vertical position. 1. Remove two locknuts (1), washers (2), screws (3), and retainer (4) from cupola bracket (5). Discard locknuts. 2. Support cover (6). Remove 12 springs (7), shield (8), two fiber washers (9), and cover from cupola. 3. Remove locknut (10) and screw (11) from cover (6). Discard locknut. 0051 00-1

Privacy Statement
Press Release
Contact