TM 9-2350-277-34 SERVICE UPON RECEIPT — Continued 0013 00 Hull Personnel heater/ feed line (1)   Remove shipping tape from heater external exhaust and intake elbows. (2)   Remove shipping tape from end of disconnected fuel feed line. (3)   Connect feed line to heater. Hull Fuel system Full fuel tank. Hull Squad seats/ backrests Remove shipping paper and tape. Hull Commander’s seat and post Install commander’s seat and post on carrier. See your -20. Hull Periscopes (1)   Remove plugs from periscope openings. (2)   Remove periscopes from packages and install. Hull Fire Extinguishers Check for intact seals on handles. Hull Drain plugs Close hull drain plugs. Hull Closure kit Remove and store closure kit. Hull Engine air inlet grille Remove shipping tape and intake and exhause grille cover from intake and exhause grille. Hull Armor mounting inserts and screw holes. Check for loose or missing plugs in inserts and setscrews in hull screw holes. LEVEL A For level A deprocessing, perform the following procedures in addition to all the procedures for Level B deprocessing. Power Plant Compartment Engine Change engine oil.  See engine crankcase tag on filler neck and your PMCS. Power Plant Compartment Transmission Service transmission with operational lubricant.  See transmission tag on filler neck and your PMCS. Hull Final drives Service final drives with operational lubricant. See your PMCS. Checking Unpacked Equipment CHECKING EQUIPMENT 1. Perform all operator and unit PMCS. See your -10 and -20. M901A3 and M981A3 Turret PMCS are included in TM 9-2350-259-10 and TM 9-2350-259-20, and TM 9-2350-266-10 and TM 9-2350-266-20. 2. Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report he damage on Form SF 368 (Quality Deficiency Report). END OF TASK 0013 00-2