TM 9-2350-277-20-5
REPLACE M13 NBC HEATER WIRING HARNESS (M577A3 ONLY)
0808 00
THIS WORK PACKAGE COVERS:
Removal (page 0808 00-1).
Installation (page 0808 00-4).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanics Tool Kit (WP 0926 00, Item 65)
Materials/Parts
Locknut
Lockwasher (4)
Strap (as required)
Grommet
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Battery ground lead disconnected (WP 0338 00)
REMOVAL
1.
Remove four screws (1), lockwashers (2), four clamps (3) and straps (4) from weldnuts in drivers compartment.
Remove clamps from wiring harness (5) and cable (6). Discard lockwashers and straps.
NOTE
Tag all leads and cables before removing.
2.
Disconnect wiring harness (5) from control box (7).
0808 00-1