REPLACE SMOKE GENERATOR ADAPTER ACCESS PLATE TO COVER ASSEMBLY AIR HOSE (M1059A3 ONLY)

TM-9-2350-277-20-5 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
510

TM 9-2350-277-20-5 REPLACE SMOKE GENERATOR ADAPTER ACCESS PLATE TO COVER ASSEMBLY AIR HOSE (M1059A3 ONLY) 0768 00 THIS WORK PACKAGE COVERS: Removal (page 0768 00-1). Installation (page 0768 00-2). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Personnel Required Unit Mechanic References See your -10 TM 3-1040-283-10 TM 3-1040-283-20 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Circuit breaker CB1 OFF (TM 3-1040-283-10) Battery ground strap disconnected (WP 0337 00) Air pressure released from compressor reservoir (TM 3-1040-283-20) Inboard armor shield removed (WP 0771 00) Smoke generator assembly removed from bracket (WP 0755 00) REMOVAL WARNING Compressed air pressure from smoke generator can cause serious injury or death. To avoid accidents, bleed air compressor storage tank until empty before working on air compressor assembly or disconnecting any air hose. NOTE Left side and right side hoses are replaced the same way. 1. Disconnect air hose (1) from adapter plate elbow (2). 2. Disconnect air hose (1) from cover assembly quick disconnect coupling (3). 0768 00-1

Privacy Statement
Press Release
Contact