TM 9-2350-277-20-5
REPLACE FUEL TANK TO FUEL PUMP HOSE (M577A3 AND M1068A3 ONLY) —
Continued
0690 00
INSTALLATION
1.
Apply light coat of sealing compound to all external tapered threads. Do not apply sealant beyond small end of external
tapered threads.
NOTE
Flareless (compression) fittings are used on the fuel lines. When these fittings are first installed,
a sleeve is crimped on the tube or hose end. Consequently, when tubes or hoses are replaced,
new fitting sleeves are also required.
2.
If necessary, install nipple (5) in fuel cross pipe.
3.
Install shutoff valve (3) on nipple (5).
4.
Install adapter (2) on fuel pump (4).
5.
Install fuel hose (1) on adapter (2) and shutoff valve (3).
FOLLOW-THROUGH STEPS
1.
Fill fuel tanks (see your -10).
2.
Connect battery ground lead (WP 0338 00).
3.
Bleed fuel line (WP 0679 00).
4.
Start heater (see your -10). Check all fittings for leaks. Turn heater off (see your -10).
5.
Install rear floor plate (WP 0539 00) or (WP 0544 00).
6.
Start engine (see your -10).
7.
Raise and lock ramp (see your -10).
8.
Stop engine (see your -10).
END OF TASK
0690 00-3/4 blank
