TM 9-2350-277-20-4
REPLACE LEFT SIDE SPALL LINERS (M113A3 ONLY) — Continued
0505 00
NOTE
Install short track on rear of vehicle first.
When using torque wrench with adapter, torque value must be corrected. Procedure for
converting torque value is on (WP 0155 00).
2.
Install two lower rear tracks (9) and (10) and middle track (8) on hull. Secure with 12 screws (12) and washers (13).
TIGHTEN SCREWS TO 32-34 LB-FT (43-46 N•m) TORQUE.
3.
Install two lower rear tracks (9) and (10) and middle lower track (8) on support (11). Secure with 12 screws (6) and
washers (7). TIGHTEN SCREWS TO 32-34 LB-FT (43-46 N•m) TORQUE.
NOTE
If stop assemblies were removed in (Step 7), do (Step 4) and (Step 5).
4.
Slide stop assembly (5) onto outside track of upper rear track (3). Position stop 4-3/4 to 5-1/4 inches (12.1 to 14.6 cm)
from end of track. Secure stop with screw (4).
5.
Slide other stop assembly (5) onto inside track of upper rear track (3). Position stop 3/8 to 7/16 inch (0.95 to 1.11 cm)
from end of track. Secure stop with screw (4).
6.
Install upper rear track (3) on hull. Secure with 24 screws (1) and washers (2). TIGHTEN SCREWS TO 32-34 LB-FT
(43-46 N•m) TORQUE. Have helper assist.
0505 00-5
