INSTALLATION - TM-9-2350-277-20-4

REPLACE COMMANDERS HATCH CUSHIONING PAD AND HANDLE (M577A3 AND M1068A3 ONLY)

TM-9-2350-277-20-4 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 (EIC AE7) Carrier Command Post Light Tracked M577A3 2350-01-369-6085 (EIC AE7) Manual
Page Navigation
291

TM 9-2350-277-20-4 REPLACE COMMANDER’S CUPOLA MACHINE GUN MOUNT STOPS (M1059A3 ONLY) — Continued 0499 00 INSTALLATION 1. Install catch (1) on mount (2). Secure with two new lockwashers (3) and screws (4). TIGHTEN SCREWS TO 264-284 IN-LB (30-32 N m) TORQUE. NOTE Install shims as required so pin of catch contacts bracket from 5/16 to 7/16 inch (8 to 11 mm). Make sure flat surface of bracket makes contact with pin. 2. Install shims (5) and bracket (6) on carrier. Secure with two washers (7), new lockwashers (8), and screws (9). TIGHTEN SCREWS TO 264-284 IN-LB (30-32 N m)TORQUE. 3. Turn cupola until catch (1) contacts bracket (6). Measure distance from bottom of pin to top of bracket. Distance should be 5/16 to 7/16 inch (8 to 11 mm). If not, add or remove shims (5) to obtain correct measurement. END OF TASK 0499 00-3/4 blank

Privacy Statement
Press Release
Contact