TM 9-2350-277-20-4
REPAIR/REPLACE POWER PLANT REAR ACCESS PANELS — Continued
0439 00
8.
Remove four locknuts (20), screws (21), and support (22) from hull. Discard locknuts.
INSTALLATION
1.
Install support (1) on hull. Secure with four screws (2) and new locknuts (3).
2.
Install cover (4) on hull. Secure with two screws (5) and new locknuts (6).
3.
Install seven spacers (7) on hull. Secure with seven screws (8).
4.
Install seven clamps (9), washers (10), T-bolts (11), and new cotter pins (12) in hull.
NOTE
Do Step 5 for M901A3, M1068A3, and M1064A3 only. M901A3 and M1068A3 have one
snap-fastener stud and M1064A3 has two snap-fastener studs.
5.
If removed, install snap-fastener stud (13), two washers (14), and new locknut (15) on upper panel (16).
0439 00-2
