TM 9-2350-277-20-4
REPLACE STEERING WHEEL LINKAGE Continued
0430 00
15. Secure link (3) to arm (6) with screw (7), washer (8), and new locknut (9).
16. Secure other end of link (3) to arm (10) with screw (11), washer (12), and new locknut (13).
NOTE
Make sure bellows is correctly installed and seated in hull bulkhead. The bellows keeps engine
compartment fumes and/or noise from entering the drivers compartment.
17. Install bellows (1) in drivers bulkhead. Secure small end of bellows with clamp (2).
FOLLOW-THROUGH STEPS
1.
Adjust steering linkage (WP 0427 00).
2.
Install drivers power plant access panel (see your -10).
3.
Close power plant access door (see your -10).
4.
Raise trim vane (see your -10).
END OF TASK
0430 00-10