TM 9-2350-277-20-3
REPLACE TOW START CONTROL ASSEMBLY AND BEARING — Continued
0391 00
INSTALLATION
1.
Route cable assembly (12) from driver’s compartment through mounting hole in bulkhead.
2.
Install jam nut (10) and washer (11) on threaded conduit end of control cable assembly (12). Tighten jam nut.
3.
Install cable bracket (6) and bearing (9) on top of transmission. Secure with two screws (7) and washers (8). TIGHTEN
SCREWS TO 18-20 LB-FT (24-27 N m) TORQUE.
4.
Place two cable straps (1) on conduit end of cable assembly (5). Install cable straps with cable assembly on bracket (6).
Secure with two screws (2), washers (3), and new locknuts (4).
0391 00-5
