TM 9-2350-277-20-3
REPLACE DRIVER’S NIGHT VISION (DNV) (AN/VVS-2) POWER SUPPLY
CABLE ASSEMBLY (ALL EXCEPT M58)
0368 00
THIS WORK PACKAGE COVERS:
Removal (page 0368 00-1).
Installation (page 0368 00-3).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
DNV POWER switch OFF
Battery ground strap disconnected (WP 0337 00),
(WP 0338 00), or (WP 0339 00)
REMOVAL
WARNING
High voltage in the AN/VVS-2 driver’s night vision can cause serious injury or death. To avoid
accidents:
ALWAYS connect power cable to periscope BEFORE turning MASTER SWITCH and DNV
POWER switch ON.
After turning DNV. POWER and MASTER switches OFF, ALWAYS wait at least 2 minutes
BEFORE disconnecting power cable from DNV. Do not disconnect power cable until image
disappears from DNV screen.
NEVER touch the end of the cable or allow it to contact metal surfaces. Voltage could exceed
16,000 volts.
0368 00-1
