TM 9-2350-277-20-3
REPLACE REAR MAIN WIRING HARNESS (M577A3 ONLY) — Continued
0363 00
74. Connect circuit 37A lead (1) to right utility outlet lead (2).
75. If NBC unit is installed, connect circuit 415 lead (3) to NBC unit switch.
76. Connect circuit 23 lead (4) and circuit 24 lead (5) to right tail light (6).
77. Install three clamps (7) on circuit 29 lead (8). Secure ground lead (9) and clamps (7) on three weldnuts (10) with two
new lockwashers (11), three screws (12), and flat washers (13).
78. Install ground lead (9) on right fuel quantity sending unit (14). Secure with screw (15), new lockwasher (16), and new
lockwire (17).
79. Connect circuit 29 lead (8) on right fuel quantity sending unit (14).
FOLLOW-THROUGH STEPS
1.
Install rear floor plate (WP 0539 00).
2.
Connect battery ground lead (WP 0338 00).
3.
Install battery access cover (see your -10).
4.
Turn MASTER SWITCH to ON (see your -10. Check that electrical system works properly.
5.
Start engine (see your -10).
6.
Raise and lock ramp (see your -10).
7.
Stop engine (see your -10).
END OF TASK
0363 00-30
