REPLACE FUEL RETURN HOSES, TUBES, AND FITTINGS (M577A3 AND M1068A3 ONLY)

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_415

REPLACE FUEL RETURN HOSES, TUBES, AND FITTINGS (M577A3 AND M1068A3 ONLY) - TM-9-2350-277-20-2_418

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
361

TM 9-2350-277-20-2 REPLACE FUEL RETURN HOSES, TUBES, AND FITTINGS (M577A3 AND M1068A3 ONLY) 0196 00 THIS WORK PACKAGE COVERS: Removal (page 0196 00-1). Installation (page 0196 00-4). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Sealing compound (WP 0928 00, Item 56) Wiping rag (WP 0928 00, Item 65) Grommet Lockwasher (13) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Ramp lowered (see your -10) Battery ground lead disconnected (WP 0338 00) Map board removed (see your -10) Work tables removed (WP 0578 00) or (WP 0581 00 and WP 0582 00) Power plant lower rear access panel removed (WP 0439 00) Rear floor plates removed (WP 0539 00) or (WP 0544 00) REMOVAL NOTE Use wiping rag to wipe up any spilled fuel. 1. Disconnect auxiliary generator return hose (1) from tee (2). 2. Remove return tube (3) from elbow (4). 3. Remove cap (5) and elbow (4) from tee (2). 4. Remove three screws (6), lockwashers (7), and clamps (8) from weldnuts on right hull plate. Discard lockwashers. 5. Disconnect return tube (3) from tee (9) on fuel filler tube (10). 0196 00-1

Privacy Statement
Press Release
Contact