REPAIR AIR CLEANER RETAINER

FOLLOW-THROUGH STEPS - TM-9-2350-277-20-2_288

TM-9-2350-277-20-2 Carrier Personnel Full Tracked Armored M113A3 2350-01-219-7577 Carrier Command Post Light Tracked M577A3 2350-01-369-6085 Manual
Page Navigation
244

TM 9-2350-277-20-2 REPAIR AIR CLEANER RETAINER 0170 00 THIS WORK PACKAGE COVERS: Removal (page 0170 00-1). Installation (page 0170 00-1). INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0926 00, Item 65) Materials/Parts Lockwasher (8) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Trim vane lowered (see your -10) Power plant front access door open (see your -10) Air cleaner door removed (see your -10) REMOVAL 1. Release retainer handle (1) and slide out filter element (2). 2. Remove eight nuts (3), lockwashers (4), and screws (5) from retainer (6) and housing (7). Remove retainer from housing. Discard lockwashers. INSTALLATION 1. Position new retainer (6) into housing (7). Secure with eight screws (5), new lockwashers (4), and nuts (3). Tighten all nuts at this time. NOTE Check operation of retainer to make sure there is no binding during operation. If binding occurs, loosen screws and repeat Step 1. 2. Install filter element (2) and reset retainer handle (1). 0170 00-1

Privacy Statement
Press Release
Contact