TM 9-2350-277-20-2PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS), INCLUDINGLUBRICATION INSTRUCTIONS — Continued0155 00ITEMNO.INTERVALMAN-HOURITEM TO BECHECKED ORSERVICEDCREWMEMBERPROCEDUREEQUIPMENTNOT READY/AVAILABLEIF:99Semi-AnnualTurn SignalLights, StopLights, BlackoutStop Lights,Dome Lights,FluorescentLights andSwitchesa. Test operation of lights with signal control in allfour operating positions. Repair or replacedamaged or discolored lenses. Repair or replacedefective lights, control, flasher and lights.100Semi-AnnualReflectorsCheck reflectors lens. Replace damaged or missinglens.101Semi-AnnualElectricalWiringa. Tighten electrical connections and mountingbrackets. Tape frayed harness. Replace missingor damaged connectors.102Semi-AnnualSlave CableNOTELocation varies by model.a. Check the slave cable receptacle and cap fordamage, burnt condition and corrosion.103Semi-AnnualTransmission/Engine SplineDrivea. M113A3 Detection procedure for wear signs onthe transmission/engine spline drive coupling—NOTESpline drive coupling wear can be detectedin its early stages using any of thefollowing three inspection procedures. Forbest results, use all three.aSemi-AnnualTransmission/Engine SplineDrivea. The first type of inspection is the power method.This method is strictly audio based.Metallicclanking soundis heard.b. To check the spline drive coupling, fully pull outthe fuel cut-off control from the driver’sposition, so fuel can not get to the engine and itwill not start. Dry start the engine for 4-6seconds.0155 00-169
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business