STE-ICE Test Procedure

Locating the Correct Troubleshooting Procedure

TM-9-2350-277-20-1 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
30

TM 9-2350-277-20-1 INTRODUCTION TO HOW TO USE TROUBLESHOOTING—Continued 0005 00 STE-ICE Test Procedure A STE/ICE test procedure will tell you how to use the STE/ICE test equipment. You may be directed to go to a STE/ICE test procedure when performing the troubleshooting procedures. The parts of a STE/ICE test procedure are given below. INITIAL SETUP: STE/ICE TEST 67 BATTERY VOLTAGE THIS WORK PACKAGE COVERS: Test (page 0124 00-1). Maintenance Level Personnel Required Unit Mech 63T10 Equipment Condition Engine stopped (see your -10) Vehicle blocked (see your -10) STE/ICE hooked up to DCA 6 (WP 0117 00) References See your-10 TM 9-4910-571-12&P 1. Select TEST 67. 2. Press and release TEST button. CONDITIONS Engine off/MASTER SWITCH OFF. Cranking engine fuel off. Charging 1100-1300 RPM/service lights on. VOLTS 21 or more 17 or more 26 to 29.5 a. If display is erratic or shows 0 (v olts), go to: STE/ICE DCA Battery Voltage Diagnostic Troubleshooting (WP 0142 00). b. If error message appears, see TM 9-4910-571-12&P. 3. Return to troubleshooting. Unit 0124 00 TM 9-2350-277-20-1 Legend to Sample Above 1 TITLE Test number and procedure name. 2 INITIAL SETUP This tells you the tools, materials/parts, personnel, references, and equipment conditions needed to do the procedure. 3 STE/ICE HOOK UP Steps that tell you how to perform the HOOK UP/REMOVE STE/ICE test. 4 TASK STEPS Steps that tell you how to set up and perform the test. Before you begin, make sure you have all items in the INITIAL SETUP. Do all steps in the test procedure and then return to where you left off i n troubleshooting task. Continue to follow troubleshooting task instructions tofind and correct the fault. 0005 00-3

Privacy Statement
Press Release
Contact