TM 9-2350-277-20-1
STE/ICE TEST 25 FUEL RETURN PRESSURE
0120 00
THIS WORK PACKAGE COVERS:
Test (page 0120 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Personnel Required
Unit Mech 63t10
References
See your -10
TM 9-4910-571-12&P
Equipment Condition
Engine stopped (see your 10)
Vehicle blocked (see your 10)
STE/ICE hooked up to DCA 6 (WP 0117 00)
1.
SELECT TEST 25.
2.
PERFORM OFFSET TEST.
a.
Push and hold TEST button until CAL appears. Release TEST button.
b.
If VTM reads between -10 and +10, offset test passes.
c.
If offset test fails, go to: STE/ICE Test 25 Diagnostic Troubleshooting (WP 0144 00).
3.
PRESS AND RELEASE TEST BUTTON.
4.
START ENGINE AND RUN AT GOVERNED NO LOAD SPEED (WP 0155 00).
a.
If VTM reads 18 (psi) or more, test passes.
b.
If error message appears, see TM 9-4910-571-12&P.
c.
If readings are erratic or cannot be obtained, go to: STE/ICE Test 25 Diagnostic Troubleshooting (WP 0144 00).
5.
STOP ENGINE (see your 10).
6.
RETURN TO TROUBLESHOOTING.
0120 00-1/2 blank