TM 9-2350-277-20-1
TRANSMISSION LOW LUBE INDICATOR COMES ON
0073 00
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
Fitting Kit (WP 0926 00, Item 21)
Pressure Gauge Kit (WP 0926 00, Item 35)
General Mechanic’s Tool Kit (WP 0926 00, Item 65)
Personnel Required
Unit Mechanic
References
See your -10
See your PMCS
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
Parking brake off (see your -10)
Transmission in SL
Transmission oil level checked (see your PMCS)
Power plant warm
Idle speed set at 600 rpm
Trim vane down (see your -10)
Power engine access door open (see your -10)
Driver access panel removed (see your -10)
Rear access panel removed (see your -10)
T
1. Turn MASTER SWITCH to ON (see your -10).
2. Is TRANS LOW PRESSURE light ON?
YES
NO
TN
1. Go to Trans Oil Low Ppressure
Indicator Malfunctions
(WP 0056 00).
Y
1. Turn MASTER SWITCH to OFF.
2. Remove plug (1) from lube port switch (2).
3. Remove lube port switch (2) from tee (3).
4. Install pressure tester in tee (3).
5. Start engine; run at 1500 rpm (see your -10).
6. Measure lube pressure with transmission in SL. Use 160 PSI
gauge. Pressure should be greater than 4 psi.
7. Does pressure gauge read less than 4 psi?
YES
NO
YN
1. Go to Trans Oil Low Ppressure
Indicator Malfunctions
(WP 0056 00).
0073 00-1
