TM 9-2350-277-20-1
ENGINE DOES NOT CRANK—Continued
0016 00
BY
1. Inspect harness 12349873 circuit 6 (1) and 6A (2) terminal ends
on starter for corrosion and/or damage.
2. Remove harness 12349873 circuit 6/6A plug (3) from harness
12349881 jack (4) at vehicle bulkhead.
3. Inspect condition of plug and jack pins.
4. Are all parts free from corrosion and damage?
YES
NO
BYN
1. Clean and repair parts as required
(WP 0382 00).
2. Verify no faults found.
B2Y
1. Install harness 12349873 circuit 6/6A plug to harness 12349881
jack at vehicle bulkhead.
2. Perform STE/ICE test 70 starter solenoid voltage (WP 0127 00).
3. Does VTM read less than 17 volts?
YES
NO
B2YN
1. Replace starter assembly
(WP 0259 00).
2. Verify no faults found.
B3Y
1. Turn MASTER SWITCH to ON.
2. Is STEERING LOCKED indicator ON?
YES
NO
GO TO CY (PAGE 0016 00-6)
0016 00-3
