WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED)

WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) - TM-9-2350-267-34_223

WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) - TM-9-2350-267-34_225

TM-9-2350-267-34 Hull Powerpack Drive Controls Tracks Suspension and Associated Components Carrier Ammunition Tracked Manual
Page Navigation
194

10-2.16 Change 4 TM 9-2350-267-34 WINTERIZATION KIT: INITIAL INSTALLATION (CONTINUED) BQ BR BS Slide rear insulation blanket (150) over batteries. Guide free end of rear batteries ground lead (circuit 7) (149) through grommet (151) in blanket and position rear of blanket under rear winterization box tab (152). Place front insulation blanket (153) over batteries, position outer side of blanket under rear winterization box side tab (154) and position slot on imer side of blanket over stud (155) on front box. Install flat washers and wing nut on stud. Install rear batteries ground lead (circuit 7)(149) on bulkhead with two existing screws and two lockwashers. Reroute left headlight wiring harness (156) and place on top of blankets (150) and (153). BT BU Install engine coolant drain plug (157) and gasket (158) in lower main coolant tube (159). Fill engine coolant system to FULL level in accordance with vehicle article preparation procedures and air bleed note at end of this section.

Privacy Statement
Press Release
Contact