CHAPTER 7 MAINTENANCE PROCEDURES TRANSMISSION, TRANSFER AND DRIVE CONTROL ASSEMBLIES

TRANSMISSION, TRANSFER AND DRIVE CONTROL ASSEMBLIES - TM-9-2350-267-20_768

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
704

CHAPTER 7 MAINTENANCE PROCEDURES TRANSMISSION, TRANSFER AND DRIVE CONTROL ASSEMBLIES CHAPTER OVERVIEW This chapter illustrates and describes the testing and adjustments This chapter contains the following sections: of the transmission, transfer and drive control assemblies. Section I Transmission, Transfer and Drive Control Procedures are designed to show the proper sequence of actions re- assemblies - Components/Tests quired to perform the maintenance tasks. Section II Transmission, Transfer and Drive Control Assemblies - Adjustment Section I TRANSMISSION, TRANSFER AND DRIVE CONTROL ASSEMBLIES — COMPONENTS/TESTS GENERAL This section contains instructions for testing components of the Source of leakage must be determined and the condition corrected transmission, transfer and drive control assemblies. These testing to avoid damage to transmission. Notify Support Maintenance procedures are organizational maintenance. personnel. TRANSMISSION PRESSURE CHECKS PREPARATION CHECK OIL CHECK Check oil level before starting the engine. After the engine starts, check lubricating oil pressure. The minimum oil pressure is 10 psi The cross-drive transmission is lubricated by oil. Whenever the at 1000 rpm. transmission oil level is found to be low, it is due to leakage. 7-1 TA31OO91 TM 9-2350-267-20

Privacy Statement
Press Release
Contact