6-156
Change 4
TM 9-2350-267-20
STE/lCE WIRING HARNESS, DRIVERS BULKHEAD TO ENGINE DISCONNECT (12329994): REMOVAL AND INSTALLATION (CONTINUED)
REMOVAL
A
B
C
D
E
F
G
Disconnect connector (1) from bulkhead receptacle (2).
Remove harness (3) receptacle (2) from bulkhead disconnect by moving
four screws (4), four lockwashers (5), four flat washer (6), four nuts (7)
and gasket (8). Discard lockwashers.
Remove current shunt leads (9 and 10) from shunt (ll) by removing two
screws (12).
Disconnect ground lead (13) from chassis ground connection (14) by
removing screw (15) and two washers (16). Do not remove other cables
from ground connection (14). Reinstall washers (16) and screw (15).
Remove two harness leads 10V and 10R (17) from battery positive
terminal.
Remove negative battery terminal (18).
Remove two alternator leads (19 and 20).