TRAILER RECEPTACLE, WIRING HARNESS (12330246): REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)
ASSEMBLY
Regroup harness wires. Secure with electrical tape (item 60, Appx D).
INSTALLATION
A Install new gasket (14) on receptacle (13).
B
Install grommet (17) in receptacle (13).
C Screw cap (16) onto receptacle (13).
D
Install receptacle (13) with wiring harness (15).
E
Install receptacle cover (12).
F
Secure new gasket (14), trailer receptacle (13), and cover (12) to
vehicle with four screws (10) and four new lockwashers ( 11 ).
G Remove lower upper rear door control switch (p 6-61).
H Install two harness straps (6) with two screws (7), two new
lockwashers (8) and two flat washers (9).
I
Install lower upper rear door control switch (p 6-61).
J
Connect two wiring harness ground lugs (3) to vehicle mount-
DISASSEMBLY
ing studs with screw (4) and two new lockwashers (5).
A Remove electrical tape.
K Connect five connectors (1) to harness 12330252 connectors
(2).
B
Separate and isolate defective harness wires.
L
Close and secure battery compartment doors.
C Repair wires (p 2-307).
TA312820
6-129
Change 1
TM 9-2350-267-20