PASSIVE NIGHT VIEWER CABLE ASSEMBLY (12332740): REMOVAL AND INSTALLATION (CONTINUED)
REMOVAL
INSTALLATION
Disconnect cable assembly (1) connector (2) from driver’s compartment
A
dome light connector (3).
B
B Disconnect cable assembly ground wire (4) by removing one screw (5) and
C
D
E
Two lockwashers (6). Discard lockwashers.
C
If connected, disconnect cable assembly plug (7) from passive night viewer
connector. Install protective cap (8) on plug (7).
D
Remove one screw (9), one lockwasher (10), one flat washer (11) and one
retaining strep (12). Discard Iockwasher.
E
Remove cable assembly (1) from vehicle.
Connect cable assembly (1) to vehicle.
Install one screw (9), new lockwasher (l0), flat washer (l1) and retaining
strap (12).
Remove protective cap (8) from plug (7). Install plug (7) to passive night
viewer connector.
Install screw (5), two new lockwashers (6) and connect cable assembly
ground wire (4).
Connectable assembly (1) connector (2) to driver’s compartment dome
light connector (3).
6-112.1/(6-112.2 blank)
Change 4
TM 9-2350-267-20
