CARGO COMPARTMENT WIRING HARNESS (12330257): REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)
DISASSEMBLY
INSTALLATION
A
B
C
NOTE
A
Remove electrical tape only from section of harness to
be disassembled.
Remove section of electrical tape from harness.
Separate and isolate wiring harness branches.
B
Disassemble wiring branch and replace defective wires (p 2-307).
ASSEMBLY
c
A
B
Reassemble wiring branch.
D
Regroup wiring branches and secure with electrical tape (item 60, AppxD).
Install harness (8) to vehicle by installing lead (68), new lockwashers (67),
and screw (66). Push boot (65) back into position.
NOTE
For steps B, E, G, M, and R, remove screws and flat
washers from each strap before installing harness.
Install five straps (64), five flat washers (63), five new lockwashers (62), and
five screws (61).
Install two guards (60) with seven flat washers (59), seven new lockwashers
(58), and seven screws (57).
Install NBC power control box plug lead and radio disconnect receptacle
lead.
6-82.1
Change 4
TM 9-2350-267-20