6-74Change 4TM 9-2350-267-20HULL FRONT WIRING HARNESS (10921380): REMOVAL, DISASSEMBLY, ASSEMBLY AND INSTALLATION (CONTINUED)REMOVALDISASSEMBLYNOTENOTEl Remove and disassemble wiring harness only to extent neededRemove elechical tape only from section of harnessto repair defect.to be disassembled.l For wire identification, see p 6-72.A Remove section of electrical tape from harness.A Remove ground leads (1) from upper and lower fuel tanks by removing screwB Separate and isolate wiring harness branches.and two washers (2) from each lead.C Disassemble wiring branch and replace defective wires (p 2-307).BDisconnect two connectors (3 and 4) from fuel level transmitters.C Remove two snap-in connectors (5 and 6) from fuel pumps.ASSEMBLYD Disconnect 11 quick-disconnects (7 through 12) from both right and leftA Reassemble wiring branch.headlight assemblies.B Regroup wiring branches and secure with electrical tape (item 60,Appx D).ERelease connector wire (13) from bilge pump circuit breaker by removingnut and two washers (14).INSTALLATIONFDisconnect four electrical connectors (15, 16, 17 and 18).A Install wiring harness in vehicle using plastic retainers, screws, newG Release ground lead (19) by removing screw and two washers (20).lockwashers, and flat washers (21).BH Remove plastic retainers, screws, lockwashers, and flat washers (21) toInstall ground lead (19) with screw and two washers (20).release wiring harness from vehicle. Discard lockwashers.C Connect four electrical connectors (15, 16, 17 and 18).D Install connector wire (13) to bilge pump circuit breaker with nut andtwo washers (14).E Connect 11 quick-disconnects (7 through 12) to both right and leftheadlight assemblies.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
