PERSONNEL VENTILATION BLOWER: REMOVAL, CLEANING AND INSTALLATION (CONTINUED)

PERSONNEL VENTILATION BLOWER: REMOVAL, CLEANING AND INSTALLATION (CONTINUED) - TM-9-2350-267-20_1386

PERSONNEL HEATER MOUNTING CLAMP, SADDLE DUCTS, HOSES, TUBES AND DEFLECTORS

TM-9-2350-267-20 Carrier Ammunition Tracked M992 (2350-01-110-4660) Manual
Page Navigation
1279

CLEANING PERSONNEL VENTILATION BLOWER: REMOVAL, CLEANING AND INSTALLATION (CONTINUED) WARNING Dry-cleaning solvent (PD-680) is toxic and flam- mable. To prevent personal injury when using PD-680, use only in a well ventilated area. Avoid breathing vapors. If you become dizzy get fresh air immediately and seek medical attention. Avoid contact with eyes, skin and clothing. Use protec- tive goggles, gloves, and clothing. If contact is made, immediately flush with water and seek medical attention. The flashpoint for Type I dry- cleaning solvent is 100°F (38°C); for Type II it is 138°F (50°C). Do not use near open flame or ex- cessive heat. INSTALLATION A B C D E F G Clean screen (8) with dry-cleaning solvent (item 19, Appx D). H Install connector (10) on motor end of fan assembly (7). Secure with coupling (9). Install screen (8) on fan assembly (7). Install fan assembly (7) on mounting surface of bulkhead with three plates (6), three flat washers (5) and three screws (4). Install flexible hose (3) (p 14-61). Connect electrical connector (1) to receptacle (2). Place MASTER switch in ON position. Check operation of per- sonnel ventilation blower (TM 9-2350-267-10). Install fire extinguisher #1 and #3 support brackets (p 14-30). Install fire extinguisher bottles #1 and #3 (p 14-28). TA313128 14-64.1 Change 1 TM 9-2350-267-20

Privacy Statement
Press Release
Contact