14-60.6Change 4TM 9-2350-267-20ENGINE AUTOMATIC FIRE EXTINGUISHING SYSTEM TEST (VEHICLES 345 AND ABOVE) (CONTINUED)Check for following sequence1Green POWER ON light comes on immediately and stays lit.2Within 6 seconds, green PASS TEST light comes on.3After a few more seconds, the PASS light should extinguish. When thePASS light goes out the yellow FAULT light and the red LED for bothMANUAL and AUTO extinguisher should illuminate and remain on. Thered F/W LED may illuminate dining the BITE test.G Press LAMP TEST toggle switch down and check that all four lamps,four LED’s and RSI come on. Replace any lamp that is burned out. Ifany LED does not light, replace engine T/A panel (p 14-39).WARNINGIf T/A panel POWER ON lamp does not go out whenT/A panel MAINTenance switch is tinned to verticalposition, disconnect battery ground lead. DO NOTCONTINUE TEST. Troubleshoot AFES (p 2-306.2.1).H Turn engine T/A panel Maintenance switch to vertical position. Alllights on engine T/A panel will go out.ITurn MASTER switch OFF. Connect electrical connectors to engineAFES extinguisher bottle actuators.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business