TM 9-2350-261-20-4
REPLACE ELECTRONIC EQUIPMENT HEATER FUEL PUMP TO BULKHEAD
0628 00
CONNECTION HOSE (M577A2 ONLY) -- Continued
INSTALLATION
NOTE
Replacing a flareless fuel hose or tube assembly may also require new mating fittings such as
a tee, elbow, or adapter.
1.
Connect fuel hose (2) to nipple (6) and fuel pump (5).
2.
Secure hose (2) to hoses (3) and (4) with nine straps (1).
FOLLOW-THROUGH STEPS
1.
Open heater fuel shutoff valve (see your -10).
2.
Connect battery ground lead (WP 0294 00).
3.
Bleed fuel line (WP 0599 00).
4.
Start heater (see your -10). Check pump for fuel leaks. Turn heater off.
5.
Install right front and rear floor plates (WP 0436 00).
6.
Install personnel heater duct (WP 0617 00).
7.
Raise and lock ramp (see your -10).
8.
Stop engine (see your -10).
END OF TASK