TM 9-2350-261-20-1
R A M P W I L L N O T R A I S E O R F R E E F A L LS
INITIAL SETUP
Tools:
General Mechanics Tool Kit
Personnel Required:
Unit Mechanic
References:
See your -10
see your -12
(Item 30, App D)
Equipment Conditions:
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Ramp lowered (see your -10)
Drivers power plant access panel removed
(see your -10)
Power plant rear access panels removed
(see your -10)
Rear compartment floor plates removed
(page 24-36)
1. If ramp will not raise, check engine disconnect
lever. Ensure lever is locked in the OUT (engage)
position (see your -10).
2. Check ramp hydraulic fluid tank sight glass fluid
level (see your -10).
3. Is fluid level correct?
1. Inspect ramp wire rope (1) and/or pulleys (2).
2. Are wire rope and pulleys in good condition?
GO TO NEXT PAGE
1. Replace wire rope and/or
pulleys
(page 25-30 or 25-31).
2. VerIfy no faults found.
GO TO PAGE 3-187
3 - 1 8 5