TM 9-2350-261-20-11. Measure resistance on terminal board TB2 (1) be-tween terminals 3 (2) and 4 (3). Record measure-ment.2. Open drivers hatch and repeat measurement.3. Does multimeter read 0 ohms with hatch closed andinfinity with hatch open?YES1. Install a jumper wire on terminal board TB1 (1)between terminals 2 (2) and 4 (3).2. Measure resistance between wiring harness11677930 plug (4) pin K (5) and S (6).3. Does multimeter read 0 ohms?1. Replace driver’s hatch in-terlock switchI(page 17-19).2. Verify no faults found.1. Repair/replace wiringharness 11677930I(page 14-3).2. Verify no faults found.I1. Hull wiring and switches are OK.2. Faulty turret wiring. Notify your supervisor.I3-169
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business