TM 9-2350-261-20-1
1. Turn MASTER SWITCH to OFF.
2. Install circuit 38E and 38A plugs on rear dome light
switch.
3. Remove eight nuts (1), washers (2) and screws (3) from
master switch panel (4). Pull panel away from
distribution box.
4. Remove circuits 10 (5) and 38A (6) plugs from circuit
breaker (7) and front dome light switch (8).
5. Install a jumper wire between circuit 10 and 38A plugs.
6. Turn MASTER SWITCH to ON.
7. Operate rear dome light switch.
1. Remove jumper wire from circuits 10 and 38A plugs.
2. Measure voltage at circuit 10 plug.
3. Does multimeter read 17 volts or more?
GO TO PAGE 3-120.1
1. Turn MASTER SWITCH to
OFF.
2. Repair/replace wiring
harness 10917788
1. Turn MASTER SWITCH to OFF.
2. Repair wiring harness circuit 38A (page 14-3).
3. Verify no faults found.
(page 14-3).
3. Verify no faults found.
3-118
Change 3
1. Remove jumper from circuite 38E and 38A plugs.
2. Measure voltage at circuit 38E plug.
3. Does multimeter read 17 volts or more?
1. Turn MASTER SWITCH to
OFF
2. Repair rear main harness
circuit 38E (page 14-3).
3. Verify no faults found.
8. Do blackout dome lights still malfunction?
