TM9-2350-261-104.5.6.7.Remove cotter pin from towpintle on recovery vehicle.Pull up on pintle hook latch andopen pintle.Connect tow bar to tow pintle.Close tow pintle over tow bar.Check that tow pintle latchesclosed.Install cotter pin to secure pintlehook latch closed.INSTALL TOW CABLES OND I S A B L E D C A R R I E R A NDR E C O V E R Y V E H I C LEN O T ELeft rear of recovery vehicle isc o n n e c t e d t o r i g h t f r o n t o fdisabled carrier. Right rear ofrecovery vehicle is connected toleft front of disabled earner .WARNINGWhen towing withtow cables, do notdisconnectdisabled carrier’sdriveshaftsbetweendifferential and final drives.Also, do not use cables to tow acarrier more than 30 miles orfaster than 10 mph (16 km/hr).1. Install two tow cables to towhooks on front of disabled carrierand to tow hooks on rear ofrecovery vehicle in an X pattern.TOW DISABLED CARRIERWARNINGJackknifeBraking from highspeeds when youtoww i t h t o wcables or tow barcanjackknifevehicles.couldinjurepersonnel and damage vehicles.Do not tow at speeds over 10mph (16 km/hr) with tow bar.GO TO NEXT PAGE2-249
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business