TM 9-2350-247-34
REPLACE ENGINE (M548A1) Continued
0007 00
NOTE
Lubricate rod end bearings before assembling. Use GAA grease (see your -20).
23. Apply thin coat of antiseize compound to clean threads of screw (1) and two screws (2).
24. Install bracket assembly (3) on power plant. Secure with two screws (1), new lock washers (4), and nuts (5). Tighten
screws to 300-324 lb-in (34-37 Nm) torque.
25. Install screw (2) and new lock washer (6) in bottom hole of bracket assembly (3). Tighten screw to 264-288 lb-in (30-33
Nm) torque.
26. Position inner transfer shaft (7) and outer transfer shaft (8) in bracket assembly (3). Secure with screw (9) and new lock
nut (10).
0007 00-27