TM 9-2350-247-34
REPAIR WINCH POWER TAKEOFF GEAR ASSEMBLY (M548A1) — Continued
0047 00
ASSEMBLY
1.
Install new gasket (10), bearing cap (7), four new lock washers (9), and screws (8) on housing (2). Use mark on bearing
cap for proper positioning.
2.
Press new oil seal (6) in bearing cap (1) with lip of seal facing away from cap.
3.
Install new gasket (5), bearing cap (1), four new lock washers (4), and screws (3) on housing (2). Use mark on bearing
cap for proper positioning.
4.
Install two new gaskets (11), spacer (12), shifter assembly (13), four new lock washers (14), and screws (15) on
housing (2).
FOLLOW-THROUGH STEPS
1.
Install winch power takeoff on carrier (see your -20).
2.
Adjust winch power takeoff (WP 0045 00).
END OF TASK
0047 00-3/4 blank
