TM 9-2350-247-20-3 MAINTENANCE ALLOCATION CHART (MAC)—Continued 0540 00 EQUIPMENT MAINTENANCE NATIONAL TOOL REF CODE LEVEL NOMENCLATURE STOCK NUMBER NUMBER 63 H BOLT: USED TO HOLD INTERMEDIATE-RANGE CLUTCH BACKPLATE DURING DISASSEMBLY AND ASSEMBLY 4910–00–572–8701 8356186 (19207) 64 H SET, GUIDE BOLT: USED TO POSITION FRONT AND REAR OIL PUMPS, FRONT AND REAR PILOT TUBES, AND DIAPHRAGM 4910–00–572–8710 8356165 (19207) 65 F REPLACER: USED WITH 5120–00–316–9182 HANDLE TO INSTALL FRONT OIL PUMP SEAL 5120–00–672–8660 8356178 (19207) 66 H REPLACER: USED TO INSTALL TRANSFER GEARCASE RETAINER AND HOUSING BEARING CUPS 5120–00–776–1864 10886353 (19207) 67 O BAR, LIFTING: USED TO REMOVE AND INSTALL FINAL DRIVE 5120–00–918–0586 11589384 (19207) 68 H REMOVER AND REPLACER: USED TO REMOVE AND INSTALL OUTPUT SHAFT BEARING 5120–00–771–7019 10874765 (19207) 69 F REMOVER AND REPLACER: USED TO REMOVE AND INSTALL FINAL DRIVE OUTPUT SHAFT OIL SEAL 5120–00–771–7020 10875335 (19207) 70 F REMOVER AND REPLACER, OIL SEAL: USED TO REMOVE AND INSTALL FINAL DRIVE OUTPUT SHAFT SPACER, RETAINER, AND BEARING; AND WITH 5315–00–834–0118 PIN AND 5120–00–678–2796 REPLACER 5120–00–771–7018 10875326 (19207) 71 F PIN, STRAIGHT, HEADLESS: USED WITH 5120–00–771–7018 REMOVER AND REPLACER 5315–00–834–0118 MS16556–3 (96906) 72 O ADAPTER, TORQUE WRENCH: USED TO TIGHTEN POWER-TRAIN UNIVERSAL JOINT SCREWS 5120–00–977–7421 1091766 (19207) 73 F SOCKET, SOCKET-WRENCH: USED TO REMOVE AND INSTALL MASTER CYLINDER RESILIENT VALVE 5120–00–557–8171 11633523 (19207) 74 H TOOL, DIFFERENTIAL BACKLASH: USED IN CONJUNCTION WITH DIAL INDICATOR AS ALIGNING TOOL 5120–00–074–1164 10942815 (19207) 75 H DRIVER PLUG, BEARING AND BUSHING: USED TO REMOVE AND INSTALL RIGHT-ANGLE DRIVE PINION INNER AND OUTER BEARINGS 5120–00–649–8126 10865981 (19207) 0540 00-20