TM 9-2350-247-20-3 MAINTENANCE ALLOCATION CHART (MAC)—Continued 0540 00 EQUIPMENT MAINTENANCE NATIONAL TOOL REF CODE LEVEL NOMENCLATURE STOCK NUMBER NUMBER 14 H INSTALLER FLARING DIE, INSTALLER: USED WITH 4910–00–711–1918 INSTALLER BODY TO FLARE SMALL END OF INJECTOR TUBE 4910–00–711–1920 10881892 15 H REMOVER, CYLINDER LINER 5120–00–937–6140 J22490 (33287) 16 H EXPANDER, FRONT OIL SEAL: USED TO EXPAND CRANKSHAFT FRONT OIL SEAL WHEN INSTALLING ENGINE LOWER FRONT COVER 4910–00–591–6640 10949378 (19207) 17 H EXPANDER: USED TO EXPAND REAR OIL SEAL 5120–00–918–0587 KM-J-9769 (33287) 18 F HOOK, LIFTING: USED TO LIFT FLYWHEEL 4910–00–722–3877 10881880 (19207) 19 H STUD: USED TO ALIGN FLYWHEEL HOUSING OR ENGINE LOWER FRONT COVER 5120–00–872–6015 KM-J-7540 (33287) 20 H CLAMP SET: USED TO LOCATE CYLINDER LINERS WHEN INSTALLING PISTONS 5120–00–999–8618 J-21793 (33287) 21 H COMPRESSOR, PISTON RING: USED TO COMPRESS PISTON RINGS WHEN INSTALLING PISTON IN CYLINDER LINER 5120–00–901–8651 KM-J-6883 (33287) 22 H REMOVER AND REPLACER: USED TO REMOVE AND INSTALL PISTON RINGS 5120–00–494–1846 KM-J-8128 (33827) 23 H PISTON RING RETAINER: USED TO REPLACE PISTON PIN RETAINERS 5120–00–733–8874 10881874 (19207) 24 H REMOVER AND REPLACER: USED TO REMOVE AND INSTALL CAMSHAFT BEARINGS 5180–00–591–6630 10949461 (19207) 25 H PULLER KIT: USED TO REMOVE CAMSHAFT GEAR AND BLOWER GEARS 5120–00–338–6721 8708724 (19207) 26 H PULLER, MECHANICAL: USED TO REMOVE CRANKSHAFT TIMING GEAR 5120–00–740–3345 KM-J-4871 (33287) 27 H REPLACER, CRANKSHAFT TIMING GEAR: USED TO INSTALL CRANKSHAFT TIMING GEAR ON CRANKSHAFT 4910–00–736–1371 10949377 (19207) 28 F REMOVER, VALVE GUIDE: USED TO REMOVE VALVE GUIDE 4910–00–591–6632 KM-J-777 (33287) 29 F REPLACER, VALVE GUIDE: USED TO INSTALL VALVE GUIDE 5120–00–872–6014 KM-J-972 (33287) 30 H REPLACER, VALVE SEAT INSERT: USED TO INSTALL VALVE SEAT INSERTS IN CYLINDER HEAD 4910–00–603–8925 10949451 (19207) 31 F TOOL KIT, VALVE SEAT INSERT: USED TO REMOVE VALVE SEAT INSERTS 5130–00–591–6631 10949470 (19207) 0540 00-17