TM 9-2350-247-20-3
REPLACE NBC CIRCUIT BREAKER AND RELAY (M548A3) — Continued
0530 00
INSTALLATION
1.
Install circuit breaker (1) with two screws (2) and nuts (3).
2.
Install relay (4) and one end of ground lead (5) on panel with two screws (6), washers (7), new lock washers (8), and
nuts (9).
3.
Install one end of jumper (10) on bus bar (11) with screw (12), washer (13), and nut (14).
4.
Install washer (15), jumper (10), washer (16), and screw (17) on circuit breaker (1).
5.
Install washer (18), one end of jumper (19), and screw (20) on circuit breaker (1).
6.
Install washer (21), ground lead (5), washer (22), and nut (23) on relay terminal X2 (24).
7.
Install washer (25), jumper (19), washer (26), and nut (27) on relay terminal A1 (28).
8.
Install washer (29), circuit 537 lead (30), washer (31), and nut (32) on relay terminal X1 (33).
9.
Install washer (34), circuit 135G lead (35), washer (36), and nut (37) on relay terminal A2 (38).
FOLLOW-THROUGH STEPS
1.
Connect both battery negative leads (WP 0292 00).
2.
Lower driver’s seat (see your -10).
END OF TASK
0530 00-3/4 blank
