TM 9-2350-247-20-3
REPLACE LOWER CAB INSULATION
0459 00
THIS WORK PACKAGE COVERS:
Removal (page 0459 00-1).
Installation (page 0459 00-1).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0541 00, Item 57)
Materials/Parts
Cleaning compound (WP 0542 00, Item 9)
Insulation
Personnel Required
Unit Mechanic
References
See your -10
Equipment Condition
Engine stopped (see your -10)
Carrier blocked (see your -10)
REMOVAL
NOTE
Remove lower cab insulation only if inspection shows replacement is needed. These instructions
are for removal of damaged panels or damaged areas of panels.
1.
Remove as much old damaged insulation as you can by scraping. Make edges even. Cut patch to fit.
2.
Remove remaining insulation and dried adhesive with cleaning compound.
INSTALLATION
1.
Trim new insulation to fit. If panel to be installed is large, cut it into squares of about 3 feet (1 meter).
2.
Spray or swab cleaning compound on back of insulation to activate adhesive.
3.
Allow 10 to 15 seconds for adhesive to become tacky. Press insulation firmly into place at once.
END OF TASK
0459 00-1/2 blank
