TM 9-2350-247-20-2
REPLACE ROAD WHEEL HUB -- Continued
0352 00
7.
Place road wheel hub (1) on road wheel support arm (2). Completely pack cavity in hub with grease (WP 0128 00).
8.
Pack outer bearing (3) with grease (WP 0128 00). Install in road wheel hub (1).
9.
Install washer (4) and nut (5) on road wheel support arm (2). Tighten nut to adjust bearing as follows:
a.
TIGHTEN NUT (5) TO 140-150 LB-FT (190-203 NM) TORQUE. Use torque wrench.
b.
Back off nut (5) until there is no torque.
c.
TIGHTEN NUT (5) TO 70-75 LB-FT (95-102 NM) TORQUE. Use torque wrench.
d.
Back off nut to align nearest cotter pin hole in nut with cotter pin hole in road wheel support arm (2).
10. Install new cotter pin (6) in road wheel support arm (2).
11. Install new gasket (7), access cover (8), and four screws (9) on road wheel hub (1).
12. Fill road wheel hub (1) with grease (WP 0128 00).
FOLLOW-THROUGH STEPS
1.
2.
Check track tension (see your -10).
3.
Road test carrier (see your -10) to check that road wheel hub is installed properly.
END OF TASK
0352 00-5/6 blank
Change 1