TM 9-2350-247-20-2
ADJUST TRANSMISSION RANGE SELECTOR CONTROL AND LINKAGE (M548A1) --
0316 00
Continued
h.
Loosen jam nut (1) on link bearing (2). Remove lock nut (3) from screw (4). Remove link bearing (2) from range
selector control arm (5). Discard lock nut.
Place range selector shift lever (6) in drive position 1.
i.
Press transmission shift arm (7) downward to end of travel to place transmission in drive position 1.
j.
Adjust length of range selector link (8) so screw (4) will pass freely through link bearing (2) and range selector
control (5). Turn link bearing (2) to the right to lengthen or to the left to shorten range selector link (8).
k.
Check alignment of range selector link (8) with range selector control arm (5). Check alignment in all transmission
shift arm (7) positions and range selector control (9) positions.
l.
When proper alignment is completed, tighten jam nut (1) on link bearing (2) to secure adjustment of range selector
link (8).
m. Secure link bearing (2) to gear selector control arm (5) with screw (4) and new lock nut (3).
FOLLOW-THROUGH STEPS
1.
Connect wiring for neutral start switch (WP 0308 00).
2.
Start engine (see your -10).
3.
Check transmission range selector control and linkage for proper operation.
4.
Stop engine (see your -10).
5.
Lower center floor plate (WP 0394 00).
6.
Lower center seat (see your -10).
END OF TASK
0316 00-3/4 blank
