TM 9-2350-247-20-2
REPLACE DRIVE SHAFT LUBRICATION HOSE, FITTINGS, AND BEARINGS (M548A1) --
0237 00
Continued
INSTALLATION
1.
If front bearing (14) or rear bearing (11) was removed, install bearing (11) or (14) and secure with two nuts (13) and
screws (12).
2.
Put a thin coat of sealing compound on threads of elbow (8) and elbow (10), grease two fittings (12), nipple (7), nipple
(9), adapter (16), adapter (17), and adapter (1).
3.
Install elbow (10) in rear bearing (11).
4.
Install nipple (9), elbow (8), nipple (7), and elbow (6) on elbow (10).
5.
Connect hose (5) to elbow (6).
6.
Secure hose (5) to four weld nuts with four clamps (4), new lock washers (3), and screws (2).
7.
Install adapter (1) in block and connect hose (5) to adapter.
