CARRIER MOVES WITH TRANSMISSION IN SL (M548A3)

TRANSMISSION DOES NOT PIVOT STEER (M548A3)Continued - TM-9-2350-247-20-1_375

CARRIER MOVES WITH TRANSMISSION IN SL (M548A3)Continued - TM-9-2350-247-20-1_378

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
302

TM 9-2350-247-20-1 CARRIER MOVES WITH TRANSMISSION IN SL (M548A3) 0074 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Multimeter (WP 0541 00, Item 29) Slip Joint Pliers (WP 0541 00, Item 33) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) Transmission in SL position (see your -10) Cab floor plates raised (WP 0395 00) T 1. Adjust steering wheel linkage (WP 0362 00). 2. Is steering linkage free from damage and in proper adjustment? YES NO TN 1. Replace steering wheel linkage (WP 0364 00). 2. Verify no faults found. Y 1. Remove wiring harness 12313482 plug (1) from transmission jack (2). 2. Turn MASTER SWITCH ON. 3. Measure voltage between each socket on wiring harness plug (1) and ground. Multimeter should read 18 volts or more at sockets B (3), D (4), and E (5) and 0 volts for all remaining socket checks. 4. Does multimeter read less than 18 volts for sockets B, D, and E and doesn’t read 0 volts for all other sockets? YES NO YN 1. Faulty transmission beyond unit maintenance repair. 2. Notify your supervisor. 0074 00-1

Privacy Statement
Press Release
Contact