SERVICE TAILLIGHT DOES NOT OPERATE

BLACKOUT MARKER LIGHT(S) AND/OR TAILLIGHT(S) DO NOT OPERATEContinued - TM-9-2350-247-20-1_249

SERVICE TAILLIGHT DOES NOT OPERATEContinued

TM-9-2350-247-20-1 Crane (CAB) Components Recovery Vehicle Full Tracked: light Armored M578 (2360-00-439-6242) (EIC:3LA) Manual
Page Navigation
188

TM 9-2350-247-20-1 SERVICE TAILLIGHT DOES NOT OPERATE 0041 00 INITIAL SETUP: Maintenance Level Unit Tools and Special Tools General Mechanic’s Tool Kit (WP 0541 00, Item 57) Multimeter (WP 0541 00, Item 29) Personnel Required Unit Mechanic References See your -10 Equipment Condition Engine stopped (see your -10) Carrier blocked (see your -10) NOTE M548A1 and M548A3 troubleshooting procedures are the same. M548A1 procedure i s shown. T 1. Operate exterior lights in all positions (see your -10). 2. Do any exterior lights operate in any light switch positions? YES NO TN 1. Go to no exterior lights operate (WP 0034 00). Y 1. Turn main light switch on light switch to SER DRIVE. 2. Remove main harness circuit 21 plug (1) from left taillight jack (2). 3. Measure voltage between main harness circuit 21 plug (1) and ground. 4. Does multimeter read less than 17 volts? YES NO YN 1. Replace service taillight bulb (WP 0278 00). 2. Verify no faults found. 0041 00-1

Privacy Statement
Press Release
Contact