TM 9-2350-247-20-1
CONNECT/DISCONNECT 200 AMP GENERATOR TEST KIT (M548A3)—Continued
0028 00
HOOK-UP
1.
Disconnect both battery negative leads (WP 0292 00).
2.
Check all electrical connectors and wiring harnesses before connecting generator test kit.
3.
Remove plug (1) and plug (2) from voltage regulator (3).
4.
Connect diagnostic test wiring harness (4) plug (5) and plug (6) to plug (1) and plug (2).
5.
Connect diagnostic test wiring harness (4) lead 2(7) to terminal 5 (8) to test kit rheostat (9).
CAUTION
If ground lead (10) is not connected to chassis and kit rheostat, the generator could be damaged
when engine is started.
6.
Connect kit ground lead (10) to terminal 6 (11) to test kit rheostat (9) and to ground.
a.
Remove screw (12), lock washer(13), washer (14), and ground lead (15) from voltage regulator mounting plate (16).
b.
Install ground lead (10) and ground lead (15) on voltage regulator mounting plate (16) with washer (14), lock
washer (13) and screw (12).
0028 00-2
