TM 9-2350-247-10
MAINTENANCE OF CARGO COVER — Continued
0071 00
INSTALLATION
1.
If the rear support bow is stowed at the front of the cargo compartment, put it back where it belongs. Take out four
screws, flat washers, rubber washers, and two rubber pads.
2.
Position the rear support bow at the rear of the cargo compartment and fasten it with two rubber pads, four rubber
washers, flat washers, and screws.
3.
Move the three rear slide in bows from the stowage slots to their regular positions.
CAUTION
Make sure the cargo compartment cover is clean and dry before you install it. Notify unit
maintenance if it is wet, dirty, mildewed, or rotted.
4.
Pull the cargo compartment cover into position over the bows. Make sure the escape hatch is at the right rear.
5.
Fasten the cargo compartment cover to the four center bows with its nine attached tie ropes.
0071 00-3
