TM 9-2350-247-10
MAINTENANCE OF CARGO COVER — Continued
0071 00
4.
Unbuckle two web straps at each rear corner of the cargo compartment cover.
5.
Loosen the front tie down rope and unhook it from the cleats on the power plant compartment bulkhead.
6.
Untie nine tie ropes holding the cargo compartment cover to the four center bows.
CAUTION
Make sure the cargo compartment cover is clean and dry before you put it away. If you store it
wet or dirty, rot or mildew could ruin it.
7.
Take off the cargo compartment cover, fold it up, and stow it away.
8.
Take out the three rear slide in bows and stow them in the slots between the front slide in bow and the front support bow.
9.
If you don’t have the material handling kit, take out four screws, flat washers, and rubber washers, and two rubber pads
holding the rear support bow in place.
10. Move the rear support bow to the stowage position right behind the front slide in bow, and fasten it with two rubber pads,
four rubber washers, flat washers, and screws.
0071 00-2
