TM 55-2350-224-14D-8. Transport to Standard Configuration Conversion Procedure To place the M901 vehicle into standardconfiguration from transport configuration, refer to figure D-2, and proceed as follows:a. Set TURRET POWER switch to ON and MODE switch to ERECT. Use ERECTION DRIVE switchto erect launcher.b. Bleed down hydraulic system pressure, and support launcher in accordance with paragraph 1.c. Install WFOV telescope (20), ITV cover (21), 7 washers (19), and 7 bolts (18). (See fig. D-2). AdjustWFOV telescope (20) as follows; Without disturbing the ITA diopter ring, select the ITA WFOV channel(3X position on the sight select switch) for a clear, sharp image of the WFOV circular reticle. Lock-wire inplace the focusing rings for the WFOV telescope, the optical sight, and the night-sight channel objectivelens.Be sure to put split ring retainers back into position.d. Apply corrosion preventive compound (MIL-C-16173, Grade I) to 6 bolts (15).e. Install stow bracket (17), 6 washers (16), and 6 bolts (15). Repeat for- other side. (See fig. D-2).Torque bolts (15) to 50-55 foot-pounds.f. Remove 2 bolts (8), 2 washers (9), bumper (12), and shim (13) from low-stow cushion base (14) oncargo hatch. (See fig. D–2). Repeat for other bumper.g. Apply corrosion preventive compound (MIL-C-16173, Grade 1) to 2 bolts (5).h. Install shim (13), bumper (12), 2 washers (9), 2 bolts (8), 2 washers (10), and 2 nuts (11) to high-stowbracket (17). Repeat for other bumper.i. Apply corrosion preventive compound (MIL–C-16173, Grade I) to 2 bolts (5).j. Install stow position stop (7), 2 washers (6), and 2 bolts (5) to rear of erection arm. Repeat for otherstow position stop. Torque bolts (5) to 8 to 9 fret-pounds.k. Apply corrosion preventive compound (ML-C-16173, Grade I) to 4 bolts (l).l. Install launcher support (4), 4 washers (3), 4 lockwashers (2), and 4 bolts (l). Repeat for otherlauncher support. Torque bolts (1) to 25-30 foot-pounds.D -6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
