MWO 9-2320-280-35-2
c. Government Verification. All QA operations and installation checks and inspections performed by
the installer are subject to Government verification at unannounced and varying intervals. Verification
will consist of observations and inspections to confirm that practices, methods, and procedures of the
installer's written inspection plan are being properly applied; and that Government product inspection to
confirm the quality of product offered for Government acceptance does not deviate from prescribed
acceptance standards specified to in TM 9-2320-280-10, TM 9-2320-280-20, and TM 750-245-4. Any
deviations will be brought to the attention of the installer for correction.
d. In-Process Inspection. During normal assembly operations, applicable modification paragraphs
will be used to check the installer's work. After installation is complete, the vehicle will be checked IAW
the PMCS check list for correct functioning of the 3-Point Seatbelt Retrofit Kit components and to ensure
there are no defective seatbelts. Any defects noted will be corrected by the installer before the vehicle is
placed in service. All vehicles modified during a production shift will be checked to ensure product
quality.
e. Workmanship Inspection. Inspect all components installed or replaced during the installation of
the MWO for smoothness of operation and security of mounting. Correct any faults found.
14. RECORDING AND REPORTING OF THE MODIFICATION.
a. Records and reports. (Refer to DA PAM 738-750.)
b. Marking Equipment.
(1) After 3-Point Seatbelt Retrofit Kit Modification is installed, mark MWO number "9-2320-280-35-2"
in the MWO Applied Block and date applied in Date Block on MWO Instruction Plate 10930014.
NOTE
Do not remove previously installed MWO instruction plate(s) that are
permanently affixed to reinforcement panel prior to this MWO installation.
(2) Install 10930014 MWO instruction plate by drilling a 0.104-inch diameter hole within
designated area on side body reinforcement panel and secure with MS21318-20 drive screw as shown in
(3) After drive screw is installed, flatten or remove protruding excess drive screw material from
inside of side body reinforcement panel.
c. Identification Data.
Not applicable.
15. MATERIAL CHANGE (MC) NUMBER.
This MWO is authorized by MC number 1-92-06-4401.
16. MODIFICATION IDENTIFICATION.
a. When installed correctly, the 3-Point Seatbelt Retrofit Kit Modification will appear as shown in
figures 68, 69, 70, and 71 (Front Seat, Non-Armor), figure 72 (Rear Seat, Non-Armor), and figures 73, 74,
75, and 76 (Front and Rear Seats, Basic Armor).
a. After the 3-Point Seatbelt Retrofit Kit Modification is completed, the High-Mobility Multipurpose
Wheeled Vehicle should be checked for secure mounting and smooth operation. Any faults detected or
discrepancies noted will be corrected before the vehicle is returned to normal service.
31
