LO 9-2350-266-12
LUBRICATION ORDER
19 March 1990
Supersedes LO 9-2350-266-12, dated 10 April 85.
CARRIER, PERSONNEL, FULL TRACKED,
ARMORED FIRE SUPPORT,
M 9 8 1 (NSN 2350-01-085-3792)
References: TM 9-2350-266-10, TM 9-2350-266-20, TM 9-2350-261-20, TB 43-0210, and CL9100SL
Intervals (on-condition or hard time) and the
WARNING
related man-hour times are based on normal
operation. The man-hour time specified is the
Dry cleaning solvent is toxic and
time you need to do all the services pre-
flammable. Death or injury may
scribed for a particular interval. Hard time
result. To avoid death or injury,
intervals will be indicated by one of the
do the following:
following symbols as appropriate: Daily (D),
Weekly (W), Monthly (M), Semiannually (S),
and Annually (A). On-Condition (OC) oil sam-
Wear protective goggles and
ple intervals shall be applied unless changed
gloves and use only in well
by the Army Oil Analysis Program (AOAP)
ventilated area. Avoid breathing
laboratory. Change the hard time interval if
vapors.
your lubricants are contaminated or if you are
operating the equipment under adverse oper-
ating conditions, including longer-than-usual
Avoid using near open flame or
operating hours. The hard time interval may
excessive heat (flash point is
be extended during periods of low activity. If
100-138F or 38-50C).
extended, adequate preservation precautions
must be taken. Hard time intervals will be
applied in the event AOAP laboratory sup-
If you become dizzy while using
port is not available. Clean fittings before
solvent, get fresh air immediate-
lubricating. Clean parts with dry cleaning
ly and get medical aid.
solvent P-D-680. Dry before lubricating. Dot-
ted arrow points indicate lubrication on both
If contact with eyes is made,
sides of the equipment.
wash your eyes with water and
get medical aid immediately.
LEVEL OF MAINTENANCE.
The lowest
level of maintenance authorized to lubricate a
point is indicated by one of the following
NOTE
symbols as appropriate: Operator/Crew (C)
and Unit Maintenance (O).
Park carrier on level ground to
check oil levels. Check/lubricate
all oil and grease fitting points
after washing or fording.
REPORTING ERRORS AND RECOMMENDING
IMPROVEMENTS.
You can help improve
this manual. If you find any mistakes or if you
know of a way to improve the procedures,
ARMY OIL ANALYSIS PROGRAM (AOAP).
please let us know. Mail your letter or DA
AOAP is an effective maintenance diagnostic
Form 2028 (Recommended Changes to Pub-
tool and not a maintenance substitute. TB
hcations and Blank forms) direct to: Com-
43-0210 must not be interpreted to mean
mander, US Army Tank-Automotive Com-
AOAP minimizes, in any way, the need to
mand, ATTN: AMSTA-MB, Warren, Ml
48397-5000. A reply will be furnished to
employ good maintenance practices and
you.
strong maintenance disciplines.
Approved for public release; distribution is unlimited.
Card 1 of 51/(52 blank)
